Owner`s manual

Resuming a Set Speed
Suppose you set your cruise control at a desired speed
and then you apply the brake.
This, of course, shuts off
the cruise ‘control. But you don’t need to reset it.
Once you’re going about
25 mph (40 km/h) or more,
you can move the cruise control switch from
ON to
WA (resume/accelerate) briefly.
You’ll go right back up to your chosen speed and
stay there. Remember that if you hold the switch at
R/A longer, the vehicle will keep going faster until you
release the switch
or apply the brake. So unless you
want to go faster, don’t hold
the switch at WA.
Increasing Speed While Using Cruise Control
There are two ways to go to a higher speed:
0
0
Use the accelerator pedal to get to the higher speed.
Push the SET button at the end of the lever, then
release the button and the accelerator pedal. You’ll
now cruise at the higher speed.
Move the cruise switch from
ON to R/A. Hold it
there until you get up to the speed you want, and
..
1. .I
then release the switch. (To increase your speed in
very small amounts, move the switch to
R/A briefly
and then release it. Each time you,do
this, your
vehicle will go about
1 mph (1.6 kmh) faster.)
The accelerate feature will only work after
you have
set the cruise control speed by pushing the
SET button.
Reducing Speed While Using Cruise Control
There are two ways to reduce your speed while using
cruise control:
0
0
Push in the SET button at the end of the lever until
you reach the lower speed you want, then release it.
To slow down in very small amounts, push the
SET button briefly. Each time you do
this, you’ll
go 1 mph (1.6 km/h) slower.
Passing Another Vehicle While Using Cruise Control
Use the accelerator pedal to increase your speed. When
you take your foot
off the pedal, your vehicle will slow
down to the cruise control speed you set earlier.
2-39