Owner`s manual

For the vertical adjustment, state inspection stations
generally will allow a reading of plus 0.76 degrees or
minus 0.76 degrees from the center of the bubble.
If you find that the headlamp aiming needs adjustment,
follow these steps:
Adjustment screws can be turned with an
E8 Tome’
socket or T15 Tom screwdriver.
f-
i‘
1. Locate the vertical aiming screw (B) that is directly
behind the headlamp assembly.
2. Turn the vertical aiming screw until the bubble
inside the level (A) is centered at zero
“0”.
3. Check the horizontal aim
(C) and adjust as
necessary. The horizontal
aiming device is located
on the inboard side
of
each lamp. Turn the
horizontal aiming
screw
(D) until the screw
aligns with the zero “0”.
4. Recheck the vertical aim (A) to make sure it is
still correct after the horizontal aim adjustment.
Re-adjust as necessary.
i
6-37