Owner`s manual
Note that the effective transmission range
of
the
universal transmitter may differ from your hand-held
transmitter and also from one channel to another.
Training
a
Garage Door Opener Equipped
with “Rolling Codes”
If
you programmed the universal transmitter, but the
garage door will not open, and
if
your garage door opener
was manufactured after
1995,
your garage door may have
a
security
feature that changes the “code” of your garage
door opener every time it is opened or closed.
To
determine if your garage door opener has this rolling
code feature, press and hold the appropriate button
on
the universal transmitter that was programmed. If the
red light flashes rapidly for one to two seconds, then
turns
solid, your garage door opener has this feature.
To program a garage door opener with the rolling code
feature, do the following:
1.
Program your hand-held transmitter to the universal
transmitter by following the steps provided under
“Programming the Transmitter” earlier.
2.
Locate the training button on the garage door opener
receiver. The exact location and color will vary mong
brands. Refer to your garage door opener manufacturer’s
owner’s manual
to
locate the training button.
3.
Press the training button on the garage door opener
receiver for one to two seconds.
4.
Return to your vehicle and press the programmed
button on the universal transmitter until the red
light flashes rapidly (about two seconds).
5.
Release the b,utton, then press it again to confirm
it
was programmed to the garage door opener receiver.
You
may now use either the universal transmitter or
the hand-held transmitter to open your garage door.
If
you still have difficulty
in
programming and require
assistance, please call your dealer.
Erasing Channels
To erase all three programmed channels, hold down the
two outside buttons until the red light begins to flash.
Individual channels cannot be erased, but can be
reprogrammed using the procedure for programming
the transmitter explained earlier.
Accessories
Accessories for your universal transmitter are available
from the manufacturer of the unit.
If
you would like
additional information, please call
1-800-355-3515.