Owner`s manual
Temperature Button
To adjust the comfort level you want maintained inside
the car, push the TEMP button.
If
you want a warmer
comfort level, push the red arrow.
If
you want a cooler
comfort level, push the blue arrow. Your comfort setting
is shown
in
the display.
Automatic Operation
Press the AUTO button when you want the system to
automatically adjust the interior temperature to your
preference. When the system is set for automatic
operation, air will come from the floor, middle or
windshield outlets depending on the temperature inside
the vehicle, the outside temperature and sun load. Fan
speed will
vary
as the system gets to and maintains the
comfort setting you have selected through
the
use of the
TEMP button.
Fan Button
The speed of the blower fan is controlled automatically
if
you have the system set for AUTO. Pressing the
FAN button will display and hold the current blower
fan setting.
If
you want
the
blower
fan
to run at a lower speed, push
the bottom of the FAN button. The fan speed will
decrease with every push
of
the button until the lowest
speed is reached.
If
you want to increase the fan speed,
push the top of the FAN
button.
Notice the fan
j
icators in the display.
Mode
Controls
Press the
AIR
FLOW
button to deliver air through the
floor, middle or windshield outlets. The system will stay
in the selected mode until the
AUTO
button is pushed.
Press the up arrow
on
the
AIR
FLOW
button to cycle
through the available modes.
To find your comfort setting, start with the system
in
AUTO mode and the TEMP button adjusted to a display
of
75
OF
(24"
C),
give the vehicle about
20
minutes to
stabilize, then readjust your comfort setting
if
necessary.
The display will show the comfort setting for a few
seconds and then it will display the outside temperature.
If you want to see your current automatic fan speed,
airflow direction and comfort setting, press the
AUTO button.
In
cold weather, the system will delay turning on the
fan, to avoid blowing cold air. The length of the delay
depends on the engine coolant temperature and the
outside temperature. Pushing the FAN, AIR
FLOW
or FRONT buttons will override this delay, turn off the
AUTO
setting and change the fan speed.
3-3