Owner`s manual

Manual Operation
You may also manually adjust the air delivery or fan speed.
AIR FLOW This button is used to change the direction
of the airflow. The airflow choices available are FLOOR,
If the system is set for AUTO, pressing the AIR FLOW
button will display the current airflow direction and the
comfort setting. Press the
AIR FLOW up or down
button again to change
the direction of the airflow.
FLOOR-MID, MID and WINDSHIELD-FLOOR.
If the
AIR FLOW up button is selected while in the
FRONT defrost mode, the system will direct the air
toward the WINDSHIELD.
If the AIR FLOW down
button is selected while in the FRONT defrost mode, the
system will direct the air toward the
FLOOR, and the
FRONT defrost mode will cancel. Notice the arrows in
the display.
OFF: If the passenger's comfort control is turned on, it
can be turned
off by pressing the OFF button once.
Pressing the
OFF button a second time will turn off the
main system. Turning off the main system causes the fan
to turn off and the airflow to be directed to the FLOOR.
The system will still
try to keep the interior of the
vehicle at the previously chosen comfort setting. The
outside temperature will show on the display when the
system is
set to OFF.
The ventilation system always allows fresh air to flow
through the interior when the vehicle is moving even
with the system in the
OFF mode.
VENT The VENT button allows outside air to flow
through your vehicle without the air conditioning
compressor working. Selecting VENT and the AUTO
button at the same time allows the system to control
automatically without the use of the air conditioning
compressor
or the use of the RECIRC mode. To turn
off the VENT selection, push the VENT button again.
RECIRC: When RECIRC is selected, the system will
limit the amount of outside air entering your vehicle.
This is helpful when you are trying to cool the interior
of the vehicle quickly or limit the amount
of outside air
entering your vehicle for some other reason. RECIRC
and AUTO may be selected at the same time. The
system will remain in RECIRC until the ignition is
turned off, then the system will return back to the
previously selected mode. RECIRC can be selected in
all manual airflow modes except FRONT defrost.
RECIRC cannot be selected with the VENT button.
Operating RECIRC in cold temperature
or under high
humidity conditions may cause moisture to form
on the
inside
of the windshield. If this condition occurs,
deselect the RECIRC button.
3-4