Owner`s manual

1. Loosen the two bolts on the inboard edge of the
headlamp assembly. This allows you to pull out
the assembly for more hand clearance when
changing bulbs.
2. Reach into the assembly
and turn the bulb socket
one-quarter
of a turn
toward the center of the
engine compartment,
while pressing it firmly.
3.
4.
5.
6.
Remove the wire connector from the bulb by
lifting the lock tab and pulling it away from the
plastic base.
Install the bulb by putting the small tab
(D) into the
small notch in the lamp
(E).
Turn the bulb socket one-quarter of a turn making
sure the tab is properly engaged in the panel slot.
To reassemble, attach the wire connector
(A) to
the plastic base making sure the
lock tab (B) is
over the lock (C).
6-33