Navigation Manual

Add Stopover
Add Stopover: Select this screen button from the
Route screen. This feature allows you to add up to three
stopovers to the current route, between your start
point and final destination. Once a stopover has been
added, the points can be edited or deleted.
To add a stopover:
1. Press the DEST hard key.
2. Select the Add or Add Stopover screen button. This
button will only appear if a route has been
calculated.
3. Using the desired method of entering a destination,
enter the stopover. See “Destination” previously for
more information.
4. Select the route preference (Fastest, Shortest, or
Other). The system will calculate and highlight the
route.
5. Select the Start Guidance screen button. You are
now ready to start your route.
6. To add the second and third stopovers, press the
DEST hard key, then select the Add screen button,
where you would like the next stopover to fall on
the route.
7. Select the route preference (Fastest, Shortest, or
Other). The system will calculate and highlight the
route.
8. Select the Start Guidance screen button. You are
now ready to start your route.
2-25