Owner's Manual

Make sure the shift lever is fully in PARK (P)
before starting the engine. The vehicle has
an electronic shift lock release system. You must
fully apply the regular brakes before shifting
from PARK (P) when the ignition is in RUN. If you
cannot shift out of PARK (P), ease pressure on
the shift lever by pushing it all the way into
PARK (P) as you maintain brake application.
Then move the shift lever into another gear.
See Shifting Out of Park (P) on page 120
Notice: Shifting to REVERSE (R) while your
vehicle is moving forward could damage the
transaxle. The repairs would not be covered by
your warranty. Shift to REVERSE (R) only after
your vehicle is stopped.
REVERSE (R): Use this gear to back up.
To rock the vehicle back and forth in order to get
it out of snow, ice, or sand without damaging
the transaxle, see If Your Vehicle is Stuck in Sand,
Mud, Ice, or Snow on page 318.
NEUTRAL (N): In this position, the engine does
not connect with the wheels. To restart when
you are already moving, use NEUTRAL (N) only.
Also, use NEUTRAL (N) when the vehicle is
being towed.
{CAUTION:
Shifting into a drive gear while your engine
is running at high speed is dangerous.
Unless your foot is firmly on the brake
pedal, your vehicle could move very
rapidly. You could lose control and hit
people or objects. Do not shift into a
drive gear while your engine is running
at high speed.
Notice: Shifting out of PARK (P) or
NEUTRAL (N) while the engine is running at
high speed may damage the transaxle.
The repairs would not be covered by your
warranty. Be sure the engine is not running at
high speeds when shifting your vehicle.
Notice: Driving your vehicle if you notice that
it is moving slowly or not shifting gears as
you increase speed may damage the transaxle.
Have your vehicle serviced right away. You
can drive in SECOND (2) when you are driving
less than 35 mph (55 km/h) and DRIVE (D)
for higher speeds until then.
115