Owner's Manual

Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
• G Turn and Lane Change Signals. See
Turn and Lane-Change Signals on page 152.
• 2 Headlamp High/Low-Beam Changer.
See Headlamp High/Low-Beam Changer
on page 153.
• Flash-to-Pass. See Flash-to-Pass on page 153.
• N Windshield Wipers. See Windshield Wipers
on page 153.
• LQ Windshield Washer. See Windshield
Washer on page 154.
For information on the headlamps, see Exterior
Lamps on page 158.
Turn and Lane-Change Signals
To signal a turn, move the lever up or down.
The lever returns to its original position when the
turn is completed.
An arrow on the
instrument panel
cluster will flash in the
direction of the turn or
lane change.
To signal a lane change, raise or lower the lever
until the arrow starts to flash. Hold it there until the
lane change is completed. The lever will return
to its original position when released.
Arrows that flash rapidly when signaling for a turn
or lane change, or that fail to work, may indicate
a burned-out signal bulb or fuse. Other drivers will
not see the signal. See Front Turn Signal and
Parking Lamps on page 397 and Taillamps, Turn
Signal, Sidemarker, Stoplamps and Back-up
Lamps on page 398 for turn signal bulb
replacement procedures. Also see Fuses and
Circuit Breakers on page 450 for location of fuses.
A chime will sound if the turn signal is left on
for more than 3/4 mile (1.2 km).
152