Owner`s manual

Temperature Button
If the display is flashing after the climate control system
is started, there
is a problem with the system and you
should see your dealer for service.
Sun and temperature sensors automatically adjust the
air temperature, the airflow direction and the fan speed
to maintain your comfort setting. The system may
supply cooler air to the side of the vehicle toward
the sun. Be careful not
to put anything over the sensors
on top of the dash.
To adjust the comfort level you want maintained inside
the vehicle, push the TEMP button.
If you want a
warmer comfort level, push the red arrow. If you want
a cooler comfort level, push the blue arrow. Your
comfort setting is shown in the display.
Fan Button
The speed of the blower fan is controlled automatically
if you have the system set for AUTO. Pressing the
FAN button will display and hold the current blower
fan setting.
If you want the blower fan to run at a lower speed, push
the bottom
of the FAN button. The fan speed will
decrease with every push
of the button until the lowest
speed is reached.
If you want to increase the fan speed,
push the top of the FAN button. Notice the fan
indicators in the display.
Mode Controls
Press the AIR FLOW button to deliver air through the
floor, middle
or windshield outlets. The system will stay
in the selected mode until the AUTO button is pushed.
Press the up arrow on the AIR
FLOW button to cycle
through the available modes.
3-4