Instructions / Assembly

7
WARNING: Cancer and
Reproductive Harm
www.P65warnings.ca.gov
From the weatherstrip side of the door, check
weatherstrip margins and contact.
Make frame adjustments so the weatherstrip
contacts the door surface equally at the
top, middle and bottom, an even 3/8
inch to 1/2 inch when fully closed.
Secure the lock side jamb with #8 X 2-1/2 or 3 inch screws
through the pre-drilled holes at the top and bottom.
DO NOT drive screws tight at this time.
From the swing side of the door, shim above the screw
locations and make adjustments so the margins between
the door and frame are even top to bottom.
STEP 5: SHIM AT HINGE LOCATIONS & SECURE HINGE JAMB
Leave door fastened and closed with the transport clip.
Shim above the screws, behind each hinge location, and
between the opening and the jamb.
Use a 6-foot level, and re-check hinge jamb to ensure it is
plumb and straight.
Finish driving screws tight in the middle rst, then top and
bottom last.
STEP 6: ADJUST REST OF FRAME & FASTEN
Note: For double doors, make adjustments that effect the alignment,
margins and weatherstrip contact between the doors. Also follow the
Astragal Site Package Instructions for details on properly setting the slide
bolt hole locations. Re-check everywhere for plumb and square, and
an even weatherstrip contact. Finish driving all screws tight.