Instructions / Assembly

9
WARNING: Cancer and
Reproductive Harm
www.P65warnings.ca.gov
Apply sealant (polyurethane or elastomeric) at the
joint where the threshold cap meets the door jambs.
Remove the self-stick paper from the corner seal
pads and apply to the door jamb, with the bottom
lined up evenly with the top of the threshold cap.
When the pad is correctly installed, the tab is on top
and the narrow part is on the bottom.
The bottom of the pad is the same width of the
threshold cap to help with alignment during
installation.
STEP 9: INSTALL CORNER SEAL PADS (INSWING UNITS ONLY)
If sill is prepared for anchoring screws, place appropriate screws through the sill into the suboor where
needed (primarily on outswing sills).
We recommend that you provide additional frame anchoring as shown here. Certain states or jurisdictions,
notably Florida and the coast of Texas, have specic installation requirements and may require installation
in strict accordance with the product approval for a specic product. You should always check with the
local authority having jurisdiction for any specic installation requirements that may apply.
STEP 10: ADDITIONAL FRAME ANCHORING
Doors with Sidelites:
Shim above mull post or jambs
separating doors and sidelites.
Screw through the frame into the
header, adjacent to the shims.
Double Doors:
Place temporary shims above the
center of the head frame, where
doors meet. Pre-drill and insert a
screw through frame into header,
then remove the temporary shims.
Patio Doors:
Shim above the mull post(s), pre-
drill and insert a screw through
the frame into the header,
at either side of the post.