MSDS

I. Product Identification
We interpret the U.S. Occupational Safety and Health Act and Regulations, including the Hazard Com-
munication Standard 29 CFR 1910.1200 dated November 25, 1983, that these products should NOT be
considered hazardous material.
II. Product Description
Copolymer pellets used to manufacture specialty exterior building products.
III. Hazardous Ingredients and Exposure Limits
We interpret the U.S. Occupational Safety and Health Act and Regulations, including the Hazardous Com-
munication standard 29 CFR 1910.1200 dated November 25, 1983, that these products should NOT be
considered hazardous material.
IV. Typical Physical and Chemical Characteristics
Boiling Point: N/A Solubility in Water: Negligible
Vapor pressure: 20 deg. C Specic Gravity: 0.90-1.35
Vapor Density: N/A pH: N/A
% Volatile (vol): <0.4 Evaporation Rate: N/A
Freezing/Melting Point: > 120 deg. C (248 deg. F)
V. Fire, Explosion and Reactivity hazard Data
Flash Point ............................................. >329 deg. C (625 deg. F) (Setchkin)
Flammable Limits .................................. N/A
Autoignition Temperature ...................... >375 deg. C (675 deg. F) (Setchkin)
Extinguishing media ............................... Water Spray, Dry Chemical, Foam, Carbon Dioxide
Special Fire-Fighting Procedures ............. Standard Procedure, Class A Fire
Unusual Fire and Explosion Hazards ...... None
Stability Considerations.......................... None
Incompatibility With ............................. Avoid contact with strong oxidizing agents.
Hazardous Decomposition Products....... None
Hazardous Products of Combustion ....... Carbon Dioxide, Carbon Monoxide
Hazardous Polymerization ...................... Will Not Occur
VI. Health Hazard Data:
No known health hazards.
VII. Emergency and First Aid Procedures
Molten Resins: If molten material comes in contact with the skin, immerse under a running stream of water
until cooled. DO NOT attempt to remove resin from skin. Removal can cause tissue damage. Get immedi-
ate medical attention.
VIII. Spill and Leak Procedures
ese products are not listed in Federal Hazardous Waste Regulations 40 CFR 261.33 para graphs (e) or (f),
i.e. chemical products that are considered hazardous if they become wastes. ey do not exhibit any of the
hazardous characteristics listed in 40 CFR 261 Subpart C. State or local hazardous waste regulations may
apply if dierent than federal.
*HMIS (Hazardous Materials Identication System) Rating for the product as it is supplied. N/A-not applicable
BE1428 PDF 2/13
Material Safety Data Sheet