Installation Guide

Shutter Arch Top
Installation Instructions
Fig. 1 (back of assembly)
Fig. 2 (front of assembly)
1/4" hole
Step 1
Attach the Arch Top to the shutter by using the clips
provided. Align the shutter and the Arch Top on a
flat surface. Join them together by pushing each
clip on as far as it will go. Use 2 clips per Arch
Top. See Figure 1 at right for clip placement.
Step 3
Fastening the arch top to the wall is just like
fastening the shutter. With the shutter in location
against the wall, drill through the Arch Top and
wall a total of 3 1/4" with a 1/4" drill bit. See
Figure 2 at right for proper Shutter Lok location.
Step 4
Grasp the Shutter-Lok by supporting the shank,
and push it through the shutter hole and into the
wall surface. Tap the Shutter Lok gently with a
hammer to snug the shutter against the siding. Do
not over tighten , or this will cause the shutter to
dimple.
Step 2
Fasten the shutter to the wall using the instructions
supplied with the shutter.
For Raised Panel and Louvered Shutters
NOTE: Only the Quarter Round Panel Arch Top contains the Transom Clips.
Transom Clip
Transom Clip Installation
If installing a Quarter Round Panel Arch Top a
Transom Clip will also need to be installed in
addition to the 2 clips. Start by pushing one end of
the Transom Clip onto the shutter, clamping the
shutter to the arch top. Work the Transom Clip down
until the entire clip is fastened to the shutter. Be sure
the Transom Clip is pushed on as far as it will go.
See Figure 1 at right.
Note: Some shutters contain support ribs at the top.
This will need to be removed using a pair of cutters
to allow the Transom Clip to be pushed into place.
Clip
Arch Top
Shutter
Transom Clip
support rib will
need to be removed