Installation Guide

12x12 Transom Top
Installation Instructions
Fig. 1 (back of assembly)
Fig. 2 (front of assembly)
Step 1
Attach the Transom Top to the shutter by using the clips
provided. Align the shutter and the Transom Top on a
flat surface. Join them together by pushing each
clip on as far as it will go. Use 2 clips per Transom
Top. See Figure 1 at right for clip placement.
Step 3
Fastening the Transom Top to the wall is just
like fastening the shutter. With the shutter in
location against the wall, drill through the
Transom Top and wall a total of 3 1/4" with a
1/4" drill bit. See Figure 2 at right for proper
Shutter Lok location.
Step 4
Grasp the Shutter-Lok by supporting the
shank, and push it through the shutter hole
and into the wall surface. Tap the Shutter Lok
gently with a hammer to snug the shutter
against the siding. Do not over tighten , or
this will cause the shutter to dimple.
Step 2
Fasten the shutter to the wall using the
instructions supplied with the shutter.
Clip
1/4" hole
support rib will
need to be removed