Installation Guide

6" Window Header
Header Installation Instructions
Kit Contains:
1 pc. Window Header
1 pc. Window Header Base
12 pcs. Shutter Loks
Screws (quantity is dependent on header length)
Window Header Base
Window Header
Step 2
Remove the Window Header from the Window Header Base by
disengaging the lock tabs. See Figure above. Draw a
horizontal line 1/8" above the window trim. This line will be
used to properly space the Window Header from the window
trim. See Figure 2 at right.
Draw horizontal line 1/8"
above window trim
01-24-01
PAPC9166
I-0055
Fig. 2
Step 1
Begin by removing the Window Header from the Window
Header Base. This can be accomplished by disengaging the
locking tabs. Figure 1 at right shows the location of these tabs.
Note: Depending on the size of your Window Header Kit, there
may be more or less locking tabs. To release the locks, start in
the middle of the Header Assembly and pull the wall of the
Header away from the Header Base. Continue this process
working your way to the ends of the Window Header Assembly.
Fig. 1
*Optional Keystone also available for reducing size, joining 2 units, or for decorative detail.

Summary of content (2 pages)