Installation Guide

LED reference guide
LED
LED Status
Description
Network
Solid for 5 seconds
Add successful
Blink 3 times
Delete successful
Solid for 3 seconds
Device resetting
Blink 10 times
Problem detected
Alert
Solid for 3 seconds
Sensor transitioned from dry to
wet or wet to dry
Blinks 3 times
Attachment plugged in or
attachment removed
Both
Flash twice
Power up
Notices
FCC
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause Harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation of the device.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction, may cause harmful
interference to radio communication. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes and Modifications not expressly approved by Building 36 Technologies LLC can void your
authority to operate this equipment under Federal Communications Commission’s rules.
IC Notice