User's Manual

35
Split – Time elapsed between the previous event in the timeline and this listed
event.
XXX.XX (ie. 000.00 seconds to 999.99 seconds).
STRT (initiation) time is always 000.00 and begins at the beginning of the
initiation sequence.
If time goes over 999.99 seconds, time should keep running but begin
counting/displaying again at 000.00. So in that event the split would be
manually calculated at 999.99 + display time from the screen, or actual time
pulled from software tool. Note that this is unlikely with envisioned usage for
initial versions of firmware.
Probably best to calculate this split time locally based on the difference on the
timeline between the events actually being displayed rather than all events in
the timeline. The reason for this is that it will allow us to make the device run
scenarios easier to “grade” in the field by only displaying the identified
determinative stimuli in the timeline that is displayed on the device. This is
something that will be set in the programming of custom scenarios (for multi-
device or custom programmed events) or will be set locally in the settings
menu for manual mode of operation.
Main Display
000.00
MSTR
YY DD MM
24HR
BATXXX%
R
G
F
Par: Off
Settings
Mode: Manual
Save
Prog: None
ID
ACT
SPLIT
TIME
XX
STRT
XXX.XX XXX.XX
ID
XXXX
SPLIT TIME
ID
ACT
SPLIT TIME
ID
ACT
SPLIT TIME
ID
ACT
SPLIT TIME
ID
ACT
SPLIT TIME
ID
ACT
SPLIT
TIME
ID
ACT
SPLIT TIME
Link: XX
ISO: XX
Ctrl: XXXXXXXX
XXXXXXXXXXXXX