User's Manual

**Note – whenever out of main screen – all lasers are off and laser outputs (including from

manual operation) are disabled**

This menu allows the user to view drills or, edit the initiation and ending sequence for the

drills as well as define output definitions (such as hand, gun, knife etc.) for the visual stimuli

of the drills.

This menu allows the user to change the initiation and ending sequence for the standard

drills (geezer mode). It also allows them to edit the output definitions for the

Default initiation is an audio output of .5s

Default ending is four audio outputs of .5s

Scrolling down and selecting each drill will bring up a new screen displaying the drill

information.

There are currently 12 standard drills. Scrolling up/down will take the user to the other

drills.

These drills are not editable in terms of output or timing.

The same initiation will apply to all drills. Appropriate colors should be applied to the table,

just like on the main screen table.

Initiation (STRT) and END sequences apply as follows: Note that the start and end

sequences run on their own separate timelines.

Main Display > Settings > Drills + Custom Prog > Pre-set Drills

Pre-set Drill Menu

Change Initiation Seq

Drills

Default

Drill 01

Drill 02

Drill 03

Drill 04

Change End Seq Default

Initiator Sequence (ie. .5

sec audio)

Drill Timer Starts

End Sequence

Device R G F

MM --------- --------- ----------