User's Manual

**Note – whenever out of main screen – all lasers are off and laser outputs (including from

manual operation) are disabled**

This page allows the user to either select, delete, or to edit a custom end

sequence.

Scrolling down to an Act and selecting it allows the user to edit that event.

(Brings up the next slide/menu for that individual event).

Selecting “Name Sequence” should allow the user to change the default name

(ENDXXXXXXXXX)

The end sequence table should scroll.

Selecting Delete should create a “Are you sure you want to delete this?” pop-

up to verify the action before deletion.

DELAY time is the time from the end of the last event in the scenario until the

time when the end sequence begins.

Main Display > Settings > Drills + Custom Prog > Manage

Custom Scenarios > Edit Custom Scenario > Change End > Edit

End Sequence

Edit End Sequence

<< Change End Sequence

Act Proj Blink Time

MMGON ---- ---- XXX.XX

MMGOFF ---- ---- XXX.XX

MMRON ---- ---- XXX.XX

MMFON ---- ---- XXX.XX

Act

+ End Sequence Event

Select this sequence

Delete this sequence

Change Name

END00000001

Delay

000.00