User's Manual

**Note – whenever out of main screen – all lasers are off and laser outputs (including from

manual operation) are disabled**

This menu allows the user to choose what device outputs are displayed on the main screen

in MANUAL mode or DRILL mode.

The Start STRT will always display.

Default in these modes is ALL

In PARSET mode the par stimulus will always display. There will be no options.

In CUSTOM mode these values will be pulled from what is defined in the custom program,

however, the user may change the values for the local display here if desired.

In all cases, all data is collected and stored (if saved) with the run. This function simply acts

as a data filter to make use of the display and the data more user friendly (in other words,

the user can define that only the specific stimuli which indicate deadly force should be used

are displayed).

_______________________________________________________________

In CUSTOM Mode the user can choose to remove any of the visual outputs from the Master Device from

the data displayed on the main screen.

The user can choose to remove any of the visual outputs and the audio output from the any of the linked

devices from the data displayed on the main screen. Use may also pre-set settings for ISO tools (if used).

The screen should scroll down with the down arrow to show all options for the custom scenario.

The user has the option, after having made manual changes, to return to the settings programmed with the

current custom program being run.

Filter Display

<<Edit Custom Scenario

Dvc

-------

Stimulus Projection

-------

CSTM000000001

Main Display > Settings > Drills + Custom Prog > Manage

Custom Scenarios > Edit Custom Scenario> Filter Display

-------

No pre-set Filters

Shot Isolation