User's Manual

83
**Note – whenever out of main screen – all lasers are off and laser outputs
(including from manual operation) are disabled**
Allows the user to enter the menu where they can adjust the outputs.
The user can disable the device audio. This applies in all modes.
I don’t think the current rev allows us to adjust intensity on the outputs
because we took out the ability to adjust current and voltage. If this is
accurate, you can take out this menu item. We may consider this for a future
gen of the NURO. If it can be applied, the setting here will be applied in all
modes.
Blink should produce the options of STDY (steady, no blinking), 0.25 (1/4
second blinking) or 0.75 (3/4 second blinking)
The rest of the adjustments made here are applied in manual mode, parset
mode, and drill mode. They will not apply in custom mode.
Defaults are max output power (if applicable) and STDY output for all options.
Manage Outputs
<< Settings
Adjust Volume (1-20)
Restore Default settings
Audio
20
Output
Main Display > Settings > Manage Outputs
STDY
Disable Device Audio

Adjust Intensity (1-20)
Red Laser
20
Blink
STDY
Adjust Intensity (1-20)
Green Laser
Blink
STDY
Forest Laser
20