User's Manual

34
Act – This is the actual event being “measured” or displayed in the timeline.
String Options
BUZZ *New* Eliminate “BUZZ”
STRT *New* - Initiation sequence begins (customizable but by default is a .5 sec audio output from the
Master/Repeater device).
GON – “Green” Laser On
G0.25 – “Green” Laser blink 0.25s
G0.75 – “Green” Laser blink 0.75s
GOFF – “Green” Laser Off
RON – “Red” Laser On
R0.25 – “Red” Laser blink 0.25s
R0.75 – “Red” Laser blink 0.75s
ROFF – “Red” Laser Off
FON – “Forrest” Laser On
F0.25 – “Forrest” Laser blink 0.25s
F0.75 – “Forrest” Laser blink 0.75s
FOFF – “Forrest” Laser Off
AON – Audio (buzzer) On *New*
AOFF – Audio (buzzer) Off *New*
SXXX – Shot Input Received (Shots 001 – 999 are numbered sequentially in order as they are received by
the device regardless of source. Later processing (laptop-based software) can do future refinement to sort
by input location, ie. which ISO tool the shots come from. More shots will start count again at 001
requiring manual calculation or software tool for analysis (note the difference here possibly between what
is displayed here and what is stored in the database – where the display is a standard calculation of the
database value). Of note here, when ISO tools are linked/enabled, the Master/Repeater device internal
function of detecting shots is disabled. It’s one method or the other, not both)
END – Applies only in Drill and Custom modes. Ending Sequence Begins (customizeable but by default is
four .5 sec audio outputs from the Master/Repeater device)
Main Display
000.00
MSTR
YY DD MM
24HR
BATXXX%
R
G
F
Par: Off
Settings
Mode: Manual
Save
Prog: None
ID
ACT
SPLIT
TIME
XX
STRT
XXX.XX XXX.XX
ID
XXXX
SPLIT TIME
ID
ACT
SPLIT TIME
ID
ACT
SPLIT TIME
ID
ACT
SPLIT TIME
ID
ACT
SPLIT TIME
ID
ACT
SPLIT
TIME
ID
ACT
SPLIT TIME
Link: XX
ISO: XX
Ctrl: XXXXXXXX
XXXXXXXXXXXXX