User's Manual

**Note – whenever out of main screen – all lasers are off and laser outputs

(including from manual operation) are disabled**

This menu allows the user to choose what device outputs are displayed on the

main screen in MANUAL mode or DRILL mode.

The Start STRT will always display.

The End END will always display.

Default in MANUAL or DRILL modes is all stimuli being selected.

In PARSET mode the par stimulus will always display. There will be no options.

In CUSTOM mode these values will be pulled from what is defined in the

custom program, however, the user may change the values here if desired.

In all cases, all data is collected and stored (if saved) with the run. This

function simply acts as a data filter to make use of the display and the data

more user friendly (in other words, the user can define that only the specific

stimuli which indicate deadly force should be used are displayed).

_______________________________________________________________

In DRILL Mode the user can choose to remove any of the visual outputs from

the data displayed on the main screen. The user can scroll to any of the “X”

boxes and either select or not select it to change the status. “X” means that

the stimulus will display. User can also select or not ISO tools linked to device.

In the “Data” field (-----), any data definition assigned to that stimulus will be

displayed.

Main Display > Settings > Filter Display (Drill)

Filter Display Menu

<< Settings

DRILL

Dvc

-------

Stimulus Projection

Shot Isolation

Reset Programmed Settings

ALL DRILLS