User's Manual

**Note – whenever out of main screen – all lasers are off and laser outputs

(including from manual operation) are disabled**

This menu allows the user to choose what device outputs are displayed on the

main screen in MANUAL mode or DRILL mode.

The Start STRT will always display.

Default in these modes is ALL

In PARSET mode the par stimulus will always display. There will be no options.

In CUSTOM mode these values will be pulled from what is defined in the

custom program, however, the user may change the values here if desired.

In all cases, all data is collected and stored (if saved) with the run. This

function simply acts as a data filter to make use of the display and the data

more user friendly (in other words, the user can define that only the specific

stimuli which indicate deadly force should be used are displayed).

_______________________________________________________________

In MANUAL Mode the user can choose to remove any of the visual outputs

from the Master Device from the data displayed on the main screen.

The user can choose to remove any of the visual outputs and the audio output

from the any of the linked devices (including shot isolation tools) from the

data displayed on the main screen.

The screen should scroll down with the down arrow to show all linked

projection devices and shot isolation devices (if any).

Main Display > Settings > Filter Display (Manual)

Filter Display Menu

<< Settings

MANUAL

Dvc

-------

Stimulus Projection

Shot Isolation

-------

No pre-set filters

Manual