Installation guide

F-15
Commands
x25dxlate Command
Purpose
Updates or displays translate information in the IP/X.25 HiSpeed WAN Comm. translate
table.
The x25dxlate command has to be used instead of x25xlate command when using
HiSpeed WAN Comm. adapters.
Syntax
x25dxlate [ –h HostName ] [ –a ] [ –o Options ] [ –d ] [ –s ] [ –z ]
x25dxlate
–h HostName –o Options–a
–d –s –z
Description
The x25dxlate command updates or displays IP/X25 translate information. The translate
table allows Internet addresses used by the Internet Protocol (IP) to be mapped to specific
X.25 virtual circuits with specific X.25 circuit characteristics. New entries and updates to
existing entries are written to or deleted from the IP/X.25 High Performance translate table.
This is only valid for IP over an HiSpeed WAN Comm. adapter.
Note: Users must have root authority to issue the x25dxlate command.
The x25dxlate command uses the gethostbyname subroutine to obtain the IP address of a
specified host. Therefore, the host name specified must exist in the /etc/hosts file or be
retrievable from a name server.
If the command is completed successfully, a value of 0 is returned.
If the command is unsuccessful, a value of –1 is returned.
The IP/X25 HiSpeed WAN Comm. translate table can be updated using the System
Management Interface Tool (SMIT).
Flags
–a Adds or changes the specified options for the given host name.
–d Deletes the specified host.
–h HostName Specifies the host name to use for add, delete and show flags.
–o Options Specifies options for the given host name. Valid values are:
vc_type
Specifies the X.25 virtual circuit type. The two valid values are:
1 for a switched virtual circuit (SVC),
2 for a permanent virtual circuit (PVC).
The parameters for SVC and PVC are as follows:
SVC Parameters (vc_type=1)