Installation guide

3-11
Installation
Cable Connection on a 1Port HiSpeed WAN Comm–B adapter – V24
V24
V24 attachment cable
90 246 001–001
76 729 218–001
76 706 767–001
and
Figure 31. 1Port HiSpeed WAN Comm–B–V24 Board
Warning: V24 attachment cable
Both ends of the V24 attachment cable are equipped with a 25-pin male connector, but
these two connectors are not the same, so be careful when you connect this type of cable.
To distinguish which connector to plug into the distribution box, look at the identification
written on the cable, near the connectors.
– Near the connector to be plugged into the distribution box, the identification begins
with: SYSTEM END
– Near the other connector, the identification begins with: DEVICE END
Cable Connection on a 1Port HiSpeed WAN Comm–B adapter – V35
The V35 attachment cable may be one of the three cables listed on the figure 32.
V35
V35 attachment cable
76 729 218–001
76 706 768–001
and
76 958 248–001
76 958 300–001
76 958 153–001
Figure 32. 1Port HiSpeed WAN Comm–B–V35 Board
Cable Connection on a 1Port HiSpeed WAN Comm–B adapter – V11
V11
V11 attachment cable
76 729 218–001
76 706 769–002
and
90 166 001–002
Figure 33. 1Port HiSpeed WAN Comm–B–V11 Board