User`s guide

7-5
Cleaning an Optical Disc
A dusty Optical Disc or dust-accumulated in a tray causes the device to fail to read the data correctly.
Follow the procedure below regularly to clean the tray and an Optical Disc:
1. Make sure that the server is powered on (the POWER/SLEEP LED is lit).
2. Press the Eject button on the front of the Optical Disc Drive.
The tray comes out.
3. Hold the Optical Disc lightly and take it out from the tray.
NOTE: Do not touch the signal side of the Optical Disc with your fingers.
4. Wipe the tray with a dry soft cloth.
IMPORTANT: Do not wipe the lens of the Optical Disc Drive. Doing so may damage the
lens and may cause a malfunction of the drive.
5. Press the Eject button or gently push the front of the tray front to close it.
6. Wipe the signal side of the Optical Disc with a dry soft cloth.
IMPORTANT: Wipe Optical Discs from the center to the outside. Use only a specific
Optical Disc cleaner if necessary. Cleaning an Optical Disc with record spray/cleaner,
benzene, or thinner causes damage to the Optical Disc contents. At worst, inserting the
Optical Disc into the server may cause a failure.
OK
NG