User`s guide

D-11
Applying the "Updating the System" Process
"Updating the System" applies the drivers necessary for the NovaScale R480 E1 Series.
Follow this process after Hotfix for Windows x64 (KB921411) or Hotfix for Windows Server 2003 (KB921411) has
been applied.
NOTE: If you install the Windows CD-ROM that contains Service Pack 2 to your system,
you do not have to apply the Service pack 2 again.
1. Log on to the system using an account with administrator privileges (e.g.administrator).
2. Insert the EXPRESSBUILDER DVD into the CD-RW/DVD-ROM drive of server.
The Windows Autorun Menu will be displayed
3. Left-click on [Setup Windows], and then click [Update the system].
NOTE: You can also right-click the Autorun Menu.
Follow the on-screen messages to proceed to the application.
The [OK] dialog box is displayed.
IMPORTANT: During the "Updating the System" process, the following message may be
shown, but there is no impact to the operation.
Do not click [cancel] since it disappears after a few seconds.
4. Click [OK] to restart the system.
5. Remove the EXPRESSBUILDER DVD from the CD-RW/DVD-ROM drive immediately when the system
restarts.