User`s guide

4-2
Starting the SETUP Utility
Powering on the server starts the POST (Power On Self-Test) and displays its check results. If a full screen logo is
displayed, press Esc.
After a few seconds, the following message appears at bottom left of the screen.
Press <F2> to enter SETUP or Press <F12> to boot from Network
Press F2 to start the SETUP utility and display its Main menu.
If you have previously set a password with the SETUP utility, the password entry screen appears. Enter the password.
Enter password:[ ]
Up to three password entries will be accepted. If you fail to enter the password correctly for three consecutive times, the
server halts. (You can no longer proceed.) Power off the server.
NOTE: The server is provided with two levels of password: Supervisor and User. With the
Supervisor password, you can view and change all system parameters. With the User
password, system parameters available for viewing and changing are limited.