Installation manual

. .
11
WIRING CONNECTIONS
H2/4 BROWN Wire (Horn Output)
The BROWN wire will provide a (-) negative output for the vehicles
horn or optional siren hookup.This wire is a transistorized low current
200mA output, and should only be connected to the low current ground
output from the vehicle's horn switch.
H2/5 RED Wire (System +12volt Constant Power)
Connect the RED wire to a constant +12 volt source.
H3: 4-PIN BLACK CONNECTOR (Windshield Receiver / Antenna)
The windshield receiver/antenna mounts on the inside of the front windshield.
We suggest you mount it on the lower left or upper left-hand side of
windshield.
Warning! Do not mount in such a manner that it obstructs the drivers
view.
- The receiver/antenna whip must be vertical.
- Remove the protective tape backing and clean the are around the glass
where you are installing.
- Carefully align the receiver/antenna and apply to windshield.
- Route the black connector wire behind the trim and connect to
receiver/antenna.
- Connect the other end to the control module.
- Special considerations must be made as some newer vehicles utilize
a tinted window glass that can effectively reduce the range.
H5 9-PIN BLACK WIRING HARNESS:
This wire provides an instant shutdown for
the remote start, whenever it is grounded.
Connect the wire to the hood pin switch
previously installed. This wire must be
routed though a grommet in the firewall
and connected to the hood pin switch.
If the pin switch is to be used with an
alarm system, connect this wire with diode.
H5/1 GREY Wire (-) (Negative Safety Shut Down For Hood Switch)