Installation manual

. .
12
WIRING CONNECTIONS
H5/2 BROWN/RED (Positive Safety Shut Down or Brake Input)
This wire provides an instant shutdown for the remote starter whenever
it recieves a +12volts.Connect this wire to the output or cold side of
the brake switch that shows +12volts only when the brake is pressed.
See below diagram
Manual Transmission: When you are in manual transmission gear mode,
you also need to connect the BROWN / RED wire into the handbrake switch.
An isolation diode must be used for handbrake switched light circuits and
brake light circuit. Most handbrake wire will show +12V at rest when the
ignition is on and ground when you set the handbrake. However, if the
handbrake wire shows 0V while the handbrake is at rest, you will need to
add a relay as below.
This wire provides an instant shutdown for
the remote start, whenever it receives
+12volts. If the brake lights switch in the
vehicle switches +12 volts to the brake light circuit,
connect this wire to the output side of the brake
switch. This will allow the remote start to shut
down if an attempt is made to operate the vehicle without
the key while running under the control of the remote start. In most vehicles,
in order to shift gear, the brake pedal must be depressed. The brake input
will in turn cause the remote start unit to shut off. (See diagram.)