Installation manual

. .
13
WIRING CONNECTIONS
H5/3 THIN BLACK Wire ( Remote Start Enable or Nuetral Safety
Input)
When the THIN BLACK wire is grounded, the remote start unit is
operable. When this wire is open from ground, the remote starter is
disabled.
1. The optional remote start toggle switch can be added on to this wire
to temporally disable the remote starter. This feature is useful if the
vehicle is being serviced or stored in an enclosed area.
2. This wire can also be connected to the neutral safety switch wire in
the vehicle.
IMPORTANT NOTE: Directly connect the THIN BLACK wire to
ground when not being used. The remote starter will not start if
this wire is
not grounded.
H5/4 BLUE / WHITE Wire (Not Used)
H5/5 GREY/BLACK (Negative Diesel Wait to Start Input)
The GREY/BLACK wire is a (-) negative input for diesel vehicles only.
This wire will attach directly to the wait to start bulb on the dashboard,
or on some vehicles the ECM module. You must locate and test the wire
that will provide a ground signal when the wait to start light is on. The
correct wire will provide a (-) negative ground signal when the bulb is
on and +12volts positive when the bulb is out. There are some vehicles
that will have the opposite configuration and you will need to wire a relay
to convert the polarity. (See diagram example below)You must program
the control module for diesel mode. (See programming instructions.)
H5/6 GREEN (Negative Door Input) (Must be used for manual
transmissions)
The GREEN wire is the (-) negative ground trigger input for negative style
door circuits. This green wire will attach to the wire in the vehicle that
provides a (-) negative ground when any of the doors are opened. The
same wire in the vehicle will provide +12volts positive or 0 voltage when
the doors are closed.