Installation manual

. .

WIRING CONNECTIONS

H7/2 BLACK/VIOLET (Timer Control Channel 6 Programmable

Output)

The BLACK/VIOLET wire provides a 200mA (-) programmable (-)

negative ground output for a variety of optional devices. The output on

the BLACK/VIOLET wire is programmable from 1 to 120 seconds. (See

Alarm Feature #3 Programming Chart.)

This wire can be used to open a sunroof, or any power device you choose

to control. The BLACK/VIOLET wire must be wired to a relay when

powering any devices.

Note: factory default setting is a 1 second momentary (-) negative

ourput. (See Alarm Feature #3 Programming Chart.)

To activate this feature press the transmitter

and buttons at the

same time.

H7/3 BROWN/BLACK (Factory Rearm Output)

The BROWN/BLACK wire provides a 200mA (-) negative output for

hooking up to the vehicles factory rearm wire. For factory rearm a (-)

negative pulse is provided after the remote starter times out or is shut

down with the transmitter.

H7: 10-PIN WHITE WIRING HARNESS:

H7/1 BLUE / BLACK Wire (Ignition 3 Output)

This wire provides a 200mA (-) negative ground output that becomes

active 4 seconds before the remote start unit initializes, and remains

grounded while running.

Ignition 3 output:

Some newer vehicles use a

third ignition wire which is

required to start and keep

the vehicles engine running.

If this is the case, wire an

IGN 3 relay (not supplied) as

shown: Do not connect

any vehicle circuits together, they

are isolated for a reason.