Installation manual

. .

WIRING CONNECTIONS

7/9 ORANGE/WHITE (Ground Output When Disarmed)

The ORANGE/WHITE wire provides a 200mA (-) negative output

when the security system is disarmed. This output can be used for

activating optional devises such as memory positions for power seats.

Note: If not attaching the orange/white wire directly to the BCM

(Body control module) a relay must be used to power the device

being energized.

H7/10 Orange (Starter Disable Relay Output)

The ORANGE will provide a 500mA (-) negative output when the security

system is armed. A relay with a diode across the coil must be used when

interrupting the starter wire. If attaching more then one device to this

wire you must diode isolate each device.

H8: 2-PIN BLUE CONNECTOR FOR THE PROGRAM / VALET SWITCH:

Select a mounting location for the switch that is hidden but easily

accessible to the driver of the vehicle. Mount the valet switch in a hidden

but accessible location. Route and plug in the valet switch wires to the

control module.

H9: 2-Pin White Connector

The LED light should be mounted in a highly visible location in the dashboard,

center console or dashboard face. Provide for at least a 6mm space behind

the LED light. Once a suitable location is chosen, drill a 6mm hole then

press the LED housing into the hole. Route the LED wires to the control

module and plug it in.

H7/9

H7/10