Installation manual

. .

PROGRAMMING AND TESTING

A. Manual Transmission: When you are in manual transmission gear

mode, you also need to connect the Brown / Red wire to the emergency

or handbrake switch. An isolation diode must be used for handbrake circuit

and brake light circuit. Most handbrake wires will show +12V at rest when

the ignition is on and ground when you set the handbrake. However, if the

handbrake wire shows 0V while the handbrake is at rest, you will need to

add a relay as shown in the diagram below.

Automatic transmission gear vehicle: Uncut (leave intact) the Violet

Loop Wire.

Manual transmission gear vehicle: Cut the Violet Loop Wire and

tape the end.

Note: The system is not recommended for the manual transmission gear

vehicles with removable tops.

Note: When installing this system on a vehicle with manual transmission

the following must be hooked up:

1. Brake Light Circuit and Handbrake Circuit. (See H5/2

BROWN/RED wire connection.)

2. Negative door pin switch (see H5/6 GREEN wire connection.) or positive

door pin switch (see H5/7 VIOLET wire connection.)

Note: Vehicles with a manual transmission gear must use Engine

Checking Tach. Or Engine Checking Oil Sensor. only. (See Start

Feature Programming # 2 - 2)

B. PROGRAMMING A NEW TRANSMITTER:

Note: The control module will only retain the last 4 remote transmitters

programmed. If the transmitter memory is exceeded, the security system

will start deleting transmitters from memory in chronological order.

1. Turn the Ignition switch from OFF to ON 3 times and stay in the

ON position.

2. Within 15 seconds, push the valet/program switch 3 times and on

the 3rd push hold it in until a long chirp from horn and the LED start

to flash then release the valet/program switch. You are now in the

transmitter programming mode.

3. Press and hold any button on the transmitter until (1) chirp from the

horn and (1) flash from the parking lights confirming the first transmitter

is now programmed.

4. If you have additional transmitters (up to 4) that need to be programmed,

repeat step 3 for each transmitter.