Installation manual

. .
22
Exit: Turn the ignition switch to the OFF position, or leave it for 15
seconds. 3 long chirps and 3 parking light flashes will confirm
programming exit.
C. FEATURES PROGRAMMING:
ALARM FEATURE. #1 PROGRAMMING:
1. Turn the Ignition switch from ON to OFF 3 times and stay in the
OFF position.
2. Push the programming switch 2 times and on 2
nd
push hold it until
(1) chirp followed with a long chirp is heard, then release the switch.
You are now in the alarm feature #1 programming mode.
3. Press and release the transmitter button that corresponds to the feature
you desire to program.
a. The amount of horn chirps and LED pause will indicate the previous
setting.
b. The factory default settings will always be [1] LED flash and [1]
horn chirp.
4. Press the transmitter button again to change the feature. Simply keep
re-pressing the transmitter button until the module advances to your
desired programming setting.
Example:
a. After you hear (1) chirp, press the button again and the module will
advance to [2] LED flashes and [2] horn chirps.
b. Press the button again, the module will advance to [3] LED flash
and [3] horn chirps etc.
ALARM FEATURE #1 PROGRAMMING CHART
One Chirp with
Press One LED Pulse
Transmitter Factory Default Two Chirps with Three Chirps with Four Chirps with
Button Setting Two LED Pulses Three LED Pulses Four LED Pulses
1 Chirps off Chirps on
2
Active arming Passive arming Passive arming Active arming
without passive with passive with Passive
door locking door locking starter disable
3
Automatic Automatic
Rearm off Rearm on
PROGRAMMING AND TESTING