Installation manual
. .
24
PROGRAMMING
ALARM FEATURE #2 PROGRAMMING CHART
One Chirp with
Press One LED Pulse
Transmitter Factory Default Two Chirps with Three Chirps with Four Chirps with
Button Setting Two LED Pulses Three LED Pulses Four LED Pulses
1 0.9-second 3.5-second Double pulse Door lock with
door lock pulse door lock pulse unlock Comfort Feature
2
Ignition Ignition Ignition Without ignition
controlled door controlled door controlled door controlled door
lock and unlock lock only unlock only lock and unlock
3
Pathway Parking light Parking light turns
illumination turns on for on for 30-seconds
feature off 30-seconds upon upon and unlock
an unlock signal signal & 10-seconds
upon a lock signal
4
Disable the out Enable the out
of range check of range check
Exit: Turn ignition switch to the ON position, or leave it for 15 seconds.
3 long chirps and 3 parking light flashes will confirm programming exit.
Comfort Feature:
Some vehicles have a special comfort feature. When you lock the drivers
door with the key, and hold the key in the door for 5 to 7 seconds all the
windows in the vehicle will roll up. If you would like to operate this feature
with the remote transmitter, you can program the alarm feature # 2-1 to
Comfort Feature.
ALARM FEATURE. # 3 PRORAMMING:
1. Turn the Ignition switch ON to OFF 3 times and stay in OFF
position.
2. Push the valet/program switch 6 times and hold it in on the 6
th
push
until 3 chirps followed with a long chirp is heard and the LED turns on
then release the valet/program switch. You are now in the Alarm
feature # 3 programming mode.
3. Press and release the transmitter button that corresponds to the feature
you desire to program.