Installation manual
. .
25
PROGRAMMING
Exit: Turn ignition switch to the on position, or leave
it for 15 seconds. 3 long chirps and 3 parking light
flashes will confirm programming exit.
ALARM FEATURE #3 PROGRAMMING CHART
One Chirp with
Press One LED Pulse
Transmitter Factory Default Two Chirps with Three Chirps with Four Chirps with
Button Setting Two LED Pulses Three LED Pulses Four LED Pulses
1
2 H7/8 Lt. Green/ H7/8 Lt. Green/ H7/8 Lt. Green/
Black Wire= Black Wire= Black Wire= Start
Factory Security Dual Pulse Door Status Output
Disarm SignalUnlock (Shock Sensor
Output Bypass)
3
H5/8 White/ H5/8 White/ H5/8 White/Black
Wire=1 Pulse Wire= 2 Pulses Wire= 3 Pulses
Activate Activate Activate
4
5 + H7/6 Violet/ H7/6 Violet/ H7/6 Violet/ H7/6 Violet/
Black Wire Black Wire Black Wire Black Wire
Channel 4 Output= Channel 4 Output= Channel 4 Output=
Channel 4 Output=
Momentary Latched Output Latched output & Timer programm-
Output reset with ignition ing (set to any
on interval between
1 sec. and 2 min.)
6 + H7/5 Black/Red H7/5 Black/Red H7/5 Black/Red H7/5 Black/Red
Wire Channel 5 Wire Channel 5 Wire Channel 5 Wire Channel 5
Output = Output= Output= Output=
Momentary Output Latched Output Latched output and Timer programm-
reset with ignition ing (set to any
on interval between
1 sec. and 2 min.)
7
+ H7/2 Black/ H7/2 Black/ H7/2 Black/ H7/2 Black/
Violet Wire Violet Wire Violet Wire Violet Wire
Channel 6 Output= Channel 6 Output= Channel 6 Output=
Channel 6 Output=
Momentary Output Latched Output Latched Output and Timer programm-
reset with ignition ing (set to any
on interval between
1 sec. and 2 min.)