Installation manual

. .
27
PROGRAMMING
REMOTE START FEATURE PROGRAM MODE.
START FEATURE. # 1 PRORAMMING:
1. Turn the Ignition from ON to OFF 3 times and stay in OFF position.
2. Push the valet switch 8 times and hold it in on the 8
th
push until (4)
chirps followed with (1) long chirp is heard and the LED turns on then
release the valet/program switch. You are now in the start feature
#1 programming mode.
3. Press and release the transmitter button that corresponds to the feature
you desire to program.
START FEATURE CHART #1
One Chirp with
Press One LED Pulse
Transmitter Factory Default Two Chirps with
Three Chirps with Four Chirps with
Button Setting Two LED Pulses
Three LED Pulses Four LED Pulses
1 + Gasoline Engine
Diesel Engine Diesel Engine Diesel Engine Diesel Engine
with Wait-to- without Wait-to without Wait-to without Wait-to
Start Light Start Light 10 Start Light 15 Start Light 20
(H5/5 Grey/ seconds warm-up seconds warm- seconds warm-up
Black Wire must timer up timer timer
be connected)
2
20 Minute 30 Minute 5 Minute 10 Minute
Run Time Run Time Run Time Run Time
3
Factory Alarm Without this
Disarm with Feature
Channel 3 On
4
Constant Flashing Parking
Parking Light Light Output
Output
5
Without this Door Lock Before Door Lock After Door Lock Before
Feature Start Shut-Down Start and Door
Lock After Shut-
Down