Installation manual
. .
30
PROGRAMMING
Exit: Press the button on the transmitter 3 long chirps and 3 parking
light flashes will confirm programming exit.
IMPORTANT NOTE: You must program the Tach Signal before
trying to remote start.
ENGINE CHECKING TACH. / RPM LEARNING
1. Turn the ignition switch from OFF to ON 3 times and stay in OFF
position.
2. Push the valet/program switch 10 times and hold it until five chirps
followed with a long chirp is heard then release the valet/program
switch.
3. Press and release the transmitter
and buttons at the same time
twice [2] LED flashes and [2] chirps will confirm the system in features
RPM learning mode.
4. Within 10 seconds, start the vehicle with the key. (While the engine is
running, the parking lights and LED light will flash, if they dont, please
check your VIOLET/WHITE wire connection.
5. Press and hold the valet switch for 2 seconds until a long chirp and the
LED light flashes constant for two seconds. The RPM signal is now learned.
6. Turn off the ignition switch to stop the engine from running
7. If the crank time on the starter needs adjusted proceed to crank level
programming.
CRANK TIME ADJUST / HI OR LOW LEVEL CHECK
1. Press the
button twice on the transmitter to start the vehicle.
2. If everything goes well:
a. Press the
button twice on the transmitter to stop engine running.
You have been completed this programming successfully.
b. Press
button on the transmitter to exit the program mode. There
will be 3 long chirps and (3) parking light flashes for confirmation.
3. If the crank time is too short, (Engine not running, before the starter
stops cranking):
a. Press the
button twice on the transmitter to turn the ignition off.
Press
button on the transmitter to set proper Check Level to
Hi position. [2] LED flashes and [2] chirps will confirm this setting.
b. Repeat the step1 4.