Installation manual

. .
31
PROGRAMMING
4. If the crank time is too long, (Engine already successfully running, while
the starter remains engaged):
a. Press the
button twice on the transmitter to stop the engine
running. Press
button on the transmitter to set proper Check
Level to Low position. [1] LED flash and [1] chirp will confirm this
setting
b. Repeat the step1  4.
ENGINE CHECKING VOLTAGE
1. Turn the ignition switch from ON to OFF (3) times and stay in
OFF position.
2. Push the valet/program switch (10) times and hold it until (5)
chirps followed by a long chirp is heard then release the valet/program
switch.
3. Press the transmitter
and buttons at the same time to set the
Voltage Checking Type. (2) LED flashes and (2) chirps will
confirm this setting.
Once you complete step 3, you can adjust and test Start Timer as
below:
START TIMER PROGRAMMING (TESTING AND ADJUSTING THE CRANK
TIME)
1. Press the
button twice on the transmitter to start the vehicle.
2. If everything goes well: Wait for 15 seconds:
a. If the engine still running.
I. Press the
button twice on the transmitter to stop the engine
from running. You have completed this programming successfully.
II. Press
button on the transmitter to exit the program mode.
There will be 3 long chirps and (3) parking light flashes for
confirmation.
b. If the engine shut down after the vehicle has been started.
I. Press the
button twice on the transmitter to turn the
ignition off.
II. Press
button on the transmitter to set Check Level to LOW
position. [1] LED flash and [1] chirp will confirm this setting.
III. Repeat the step1  2.