Installation manual

. .
32
PROGRAMMING
3. If the crank time is too long, (The engine is successfully running,
while the starter is still cranking):
a. Press the
button twice on the transmitter to stop the engine.
b. Press
button on the transmitter to set proper Start Timer.
The chirp and LED pauses will confirm you have entered the
start timer mode (Decreasing the start timer is necessary.)
c. Repeat the step1  4.
4. If the crank time is too short, (The engine is not running and the
starter did not engage long enough)
a. Press the
button twice on the transmitter to turn the ignition
OFF.
b. Press
button on the transmitter to set proper Start Timer.
The chirp and LED pauses will confirm you have entered the start
timer mode. (Increasing the Start timer is necessary.)
c. Repeat the step1  4.
ENGINE CHECKING OIL SENSOR
1. Turn the Ignition switch from ON to OFF 3 times and stay in OFF
position.
2. Push the valet/program switch 10 times and hold it in on the 10
th
push until (5) chirps followed with (1) long chirp is heard and the LED
turns on then release the valet/program switch.
3. Press the transmitter and buttons at the same time to set the
Engine Checking Oil Sensor. [3] / [4] LED flashes and [3] / [4]
chirps will confirm this setting.
Once you complete step 3, you can adjust and test Start Timer as below:
START TIMER PROGRAMMING: (TEST and ADJUST)
Press the
button twice on the transmitter to start the vehicle.
1. If everything goes well:
a. Press the button twice on the transmitter to stop engine running.
You have been completed this programming successfully.
b. Press
button on the transmitter to exit the program mode. There
will be (3) long chirps and (3) parking light flashes for confirmation.