Installation manual

. .

PROGRAMMING

TESTING YOUR INSTALLATION

LED

Flashes Shutdown Mode

7 Tach. Signal has not been Re-learning the RPM (Start

learned feature #2-2)

8 The procedure of the Check Operation Manual #

Engine start memorizing Remote Start Operation B section.

for the vehicle with manaul

transmission gear is not completed.

Caution!! The follow procedure must be performed after the installation of

the remote start device. It is the responsibility of the installing technician

to complete these tests. Failure to test the unit in the following manner may

result in personal injury, property damage, or both.

1. Test the brake shutdown circuit: With the vehicle in park (P), start the

vehicle using the remote transmitter. Once the engine is running, press

the brake pedal. The vehicle should shut down immediately. If the vehicle

continues to run, check the brake circuit BROWN/RED wire (H5/2)

connection.

2. Test the hood safety shutdown circuit: Start the vehicle using the remote

transmitter. Once the engine is running, pull the hood release and raise the

hood. The vehicle should shut down immediately. If the vehicle continues

to run, check the hood pin GREY wire (H5/1) connection.

NEUTRAL START SAFETY TEST:

1. Set the vehicle parking brake.

2. Block the drive wheels to prevent vehicle movement.

3. Sitting in the vehicle, turn the ignition switch to on or run position,

but do not start the engine.

4. Step on the brake pedal and shift the gear selector into DRIVE

(D).

5. Put your foot over the brake pedal but do not press down on it. Be ready

to step on the brake to shut down the remote start device.