Installation manual

. .
39
TESTING YOUR INSTALLATION
Note: A second 4003 series diode may be required to maintain the integrity
of the hood open, shut down circuit. If this is the case, it must be installed
as shown in the diagram above. The anode (Non Stripped) side must be
connected to the GREY wire (H5/1) of the remote start unit. The cathode
(Striped) side must be connected to the hood pin switch.
METHOD 2
To connect to the key in sensor circuit as shown for method 2:
A. Locate the control wire that connects the drivers door pin switch to the
key in sensor switch.
B. Cut this wire and connect the ignition cylinder side to chassis ground.
C. Locate the key in sensor switch wire that connects the chime module to
the ignition cylinder.
D. Cut this wire and connect the ignition cylinder side to the Remote Start
Negative Safety Shut down wire GREY (H5/1), using a 4003 series
diode as shown above.
Note: A second 4003 series diode may be required to maintain the
integrity of the hood open, shut down circuit. If this is the case, it must be
installed as shown in the diagram above. The anode (Non Striped) side must
be connected to the GREY wire (H5/1) of the remote start unit. The cathode
(Striped) side must be connected to the hood pin switch.
AFTER THE CONNECTION OF THE NEUTRAL START SAFETY WIRE AS
INDICATED IN ANY OF THE PREVIOUS ALTERNATE CONFIGURATIONS,
THIS CIRCUIT MUST BE TESTED FOR OPERATION.
Retest by following the steps outlined in the NEUTRAL START SAFETY TEST
shown in this manual.