Installation manual

. .

TABLE OF CONTENTS

2 Steps Door Unlock Wire Connection

Type A Positive Switched Door Lock System .............................16

H7: 10-PIN WHITE WIRE HARNESS.............................................17

H7/1 Blue /Black wire  (-) 200mA Ignition 3 Control Output............17

H7/2 Black / Violet wire  (-)

200mA Channel 6 Programmable Output....................................17

H7/3 Brown / Black wire  (-) 200mA Programmable Output ............17

Horn Output  (Factory Default Setting)

Factory Security Rearm Signal Output

H7/4 Black / White wire  (-) 200mA

Dome Light Supervision Output ................................................18

H7/5 Black / Red wire  (-) 200mA

Channel 5 Programmable Output .............................................18

H7/6 Violet / Black wire  (-) 200mA Programmable Output .............18

Channel 4 Programmable Output  (Factory Default Setting)

Ground Output During Start (Crank)

H7/7 Red / White wire  (-) 200mAChannel 3 (Trunk) Output ...........19

H7/8 LT. Green / Black wire  (-) 200mA Programmable Output........19

Dual Pulse Door Unlock Output

Factory Security Disarm Signal Output (Factory default setting)

Start Status (Shock Sensor By-Pass Control) Output..................19

H7/9 Orange / White wire (-)

200mA Grounded Output When Disarmed ..................................20

H7/10 Orange wire  (-) 200mA Grounded Output When Armed .......20

H8. 2 PIN BLUE CONNECTOR FOR THE VALET SWITCH ................20

H9. 2 PIN WHITE CONNECTOR

FOR THE LED STATUS INDICATOR...............................................20

PROGRAMMING & TESTING:

A. AUTOMATIC / MANUAL TRANSMISSION VEHICLE ...................21

B. PROGRAMMING A NEW TRANSMITTER....................................21

C. FEATURES PROGRAMMING .................................................21-22

Alarm Feature #1 Programming ...............................................22-23

3 / 30 seconds Delay Door Ajar Error Chirp

Alarm Feature #2 Programming ...............................................23-24

Comfort Feature

Alarm Feature #3 Programming ...............................................24-26

Channel 4 (5 / 6) Timer Control Output Programming

Ground Output During Start (Crank) Programming