Installation manual

. .
TABLE OF CONTENTS
5
This remote starter with keyless entry system is designed to be
installed on fuel injected vehicles only.
 This system must be installed and wired through a safety switch
to assure that it will not start in any forward or reverse gear.
 Some automatic transmission vehicles [mainly older GM models
with a purple starter wire] have a mechanical-type park mechanism
instead of an electrical safety switch. The mechanical type does
not interrupt the starter circuit when the transmission is any gear
and does not offer the 100% level of safety required for remote
starting purposes. Therefore, you must create a circuit that will
prevent the remote starter from engaging when the key is in the
ignition.
 Once you install this system, you must verify that the vehicle will
not start any forward or reverse gear.
IMPORTANT NOTICE
Start Feature #1 Programming ................................................27-28
Safe Start (Child Safety Mode)
Temperature Start Programming
Start Feature #2 Programming ................................................28-29
Engine Checking TACH.  RPM Learning & Testing .......................30
Engine Checking Voltage  Start Timer Set-up & Testing ..............31
Engine Checking Oil Sensor  Start Timer Set-up & Testing ..........32
Turbo Mode
Range Check
RETURN TO FACTORY DEFAULT SETTING ....................................33
SHUTDOWN DIAGNOSTICS.....................................................34-35
TESTING YOUR INSTALLATION ..............................................35-39
Test the Brake shutdown circuit
Test the Hood Pin shutdown circuit
Neutral Start Safety Test
Mechanical Neutral Safety Switch Considerations
Park/Neutral ECM Input
Key In Sensor Circuits