Installation manual
. .
6
IMPORTANT NOTICE
COMPONENTS
1- Main Control Module
1- Five Button LCD Remote
Transmitter
1- 6 Pin Ignition Harness
1- 5 Pin Harness
1- 10 Pin Mini Output Harness
1- 9 Pin Mini Input Harness
1- 2 Pin Valet Switch
1- 2 Pin Led Light Harness
1- 4 Pin Antenna Harness
1- 6 Pin Door Lock Harness
1- Hood Switch
1- Hood and Window Decal
1- Installation Manual
1- Owners Manual
Read the operation manual for operating and programming routine.
Do not install any component near the brake, gas pedal or steering
linkage.
Most vehicles have an SRS air bag system. Use extreme care and
do not probe any wires of the SRS system. These wires will almost
always be located inside a bright yellow tube located near the
steering wheel column.
Check behind panels before drilling any holes. Ensure that no wiring
harness or other components are located behind the panels that
would otherwise be damaged.
Do not use conventional crimp lock or bullet connectors on any
wiring.
Do not disconnect the battery if the vehicle has an anti-theft radio
or is equipped with an airbag. Doing so may cause a warning light
to be displayed and the radio to stop functioning.
Do not leave the interior or exterior lights on for an extended
period of time. Remove the dome light fuse from the vehicles fuse
box.
Do not mount the control module until all connections have been
made and the unit is programmed and tested.
Finally place the warning sticker under the hood when the installation
is completed.