Operating instructions

©2003 JBS Technologies, LLC ©2003 JBS Technologies, LLC
4
SYSTEM FEATURES
25
Security System Features
Starter Immobilizer Prevents the vehicle from being hotwired when the system is
with Relay armed.
Remote Car Finder Helps you locate your vehicle in a crowded parking lot.
Remote Valet Remotely turn off the alarm section when not needed.
Silent Arming Remotely program the alarm to silently arm and disarm with the
remote transmitter.
Door Trigger Protection Provides protection when doors are opened.
Horn and Siren Outputs Gives you the option to connect a siren or horn, or both, to the
alarm for additional audible protection.
Remote Starter Features
Remote Programmable Remotely program your car to start at a preset temperature.
Automatic Hot and Cold Select desired temperature from 150ºF to -40ºF.
Start
Remote Programmable Remotely program your car to start every 3 hours regardless of the
Automatic Start temperature.
Remote Programmable Remotely program your vehicle to automatically start when the
Low Voltage Start battery voltage drops below 11 volts.
Remote Programmable Remotely program your vehicle to run from 5 to 25 minutes.
Run Time
Remote Programmable Remotely program a longer engine cranking for hard starting
Extended Crank Time vehicles.
Dedicated Start and Stop Uses separate buttons to start and stop the remote starter.
Buttons
Diesel Start Capability Allows you to program the unit to remote start a diesel vehicle.
Trunk Release Output
The remote car starter includes an optional output that can be used to do one of the
following: open the trunk, roll up the windows (optional module required), close the sun
roof (optional module needed) etc. This output will pulse .75 seconds when pressed and
released. In instances where a continuous signal is needed such as sun roof and power
windows, hold down Button #3 (Trunk) as long as the signal is needed to complete the
task. The parking lights will remain on as long as this button is being pressed.
Remote Car Finder (Armed Only)
When the unit is armed, press and release Button #4, the horn or siren will chirp three
(3) times and the parking lights will flash three (3) times.
Runtime Confirmation (Disarmed Only)
With the engine off, press and release Button #4 (Stop). The parking lights will begin to
flash, each flash represents five minutes of programmed runtime. Example: 5 flashes =
25 minutes.
Zone Violation Status
If the unit was violated, there will be three (3) flashes and chirps upon disarming. After
disarming, if the unit was violated, the LED will flash the appropriate number of times to
signify the violated zone. If more than 1 zone was violated, the highest priority zone is
signified. The LED will continually flash the appropriate zone violation for 1 minute or when
the ignition and brake are activated, whichever occurs first. Order of significance is doorpin,
hoodpin, then shock sensor. Shock violation, 2 LED flashes; hoodpin violation, 3 LED flashes;
doorpin violation, 5 LED flashes.
ADDITIONAL OPERATING PROCEDURES:
Valet Mode On
Press and hold the brake, turn Ignition Key to the Run position. Within five (5) seconds,
press and release Button #4. The horn will sound or the siren will chirp once, the parking
lights flash once and the LED will flash once. Valet is now on. Release the brake, turn the
ignition key off. The LED will remain lit in valet mode.
Valet Mode Off
Press and hold the brake, turn Ignition Key to the Run position. Within five (5) seconds,
press and release Button #4. The horn will sound or the siren will chirp twice, the parking
lights flash twice and the LED will flash twice. Valet is now off. Release the brake, turn the
ignition key off. The LED will now turn off.
OPERATING INSTRUCTIONS