Owner`s manual

2540
PROGRAMMING
FEATURE ‘II” PRORAMMING:
Turn the Ignition switch “ON/OFF” (3) TIMES and leave in the
“OFF” position.
Push the Program switch (4) times and hold in on the 4th push
until (2) chirps with a long chirp is heard then release the Program
switch. You are now in the feature “II” programming mode.
Press and release the transmitter button that corresponds to the
feature you desire to program.
FEATURE # II PROGRAMMING CHART
Press
Transmitter
Button
One Chirp with One
LED Pulse Factory
Default
Setting
Two Chirps with
Two LED Pulses
Three Chirps with
Three LED Pulses
1 Pathway Illumination Parking lights turn
“on” for 30-seconds
upon an unlock signal
& 10-seconds upon a
lock signal
Parking light turns
“on” for 30-seconds
upon an unlock sig-
nal & 10-seconds
upon a lock signal
2 Constant parking
Light output
Flashing parking light
output
3 Brown/Black
Wire=Security Rearm
Signal Output
Brown/Black Wire=
Ground Output dur-
ing state (crank)
4 Lt. Green/Black wire
=Dual pulse door
unlock output
Lt. Green/Black
Wire= Factory
security disarm
signal output
Lt. Green/Black
Wire=Start status
output (shock sen-
sor bypass)
EXIT: Turn Ignition to “ON” position, or leave it for 15 seconds. (3) long
horn chirps and (3) long horn chirps and (3) parking light ashes will con-
rm exit.
1.
2.
3.
OPERATION
Note: The Remote Start Unit will not start the vehicle if any one of the
following conditions exists:
The hood is opened.
The brake pedal is pressed.
Move the optional remote start enable toggle switch to OFF position.
(If installed)
The gear selector is in any gear other then “PARK or “NEUTRAL”.
B. TO OPERATE THE VEHICLE WHILE RUNNING ON THE REMOTE START:
To operate the vehicle while the engine is running on the remote starter.
Insert the ignition key and turn it to “ON” (not the crank) position.
Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON position,
the engine will shut down.
C. PIT STOP FEATURE:
This feature allows the vehicle to remain running after the key has been
removed from the ignition. This feature is useful for occasions when you
wish to exit and lock the vehicle for short periods of time, but would like
to leave the motor running and the climate control on.
Before turning off the engine press the button twice on the trans-
mitter and the LED indicator will ash (3) times to conrm enter.
Turn the ignition key to OFF position. (The engine will stay running.)
The engine will run until the pre-programmed time elapsed or shut-
down input is received.
D. TIMER START:
This unit can be pro rammed to start and run the engine every 2 or 3
hours the engine will run for the programmed time and then shut down.
IMPORTANT: Timer Start should be used only in open areas, never start
and run the vehicle in on enclosed space as a garage or carport.
This feature is designed for an extreme cold climate usage. The system
will auto start the vehicle every 2 or 3 hours to prevent engine freezing
and hard to start. A MAXIMUM OF SIX CYCLES CAN OCCUR.
ENTER
Press the button twice to remote start the vehicle. As
soon as the vehicle is running and the parking light have
turned on or ashing.
Immediately depress the button once, within (2) secs.
1.
2.
3.
4.
1.
2.
1.
2.
3.
1.
2.